Turns out, I was completely misinterpreting the lubrication factor. The GUI hint is vague, but the manual has a full flowchart of how to select the right viscosity grade.
Okay, I’ll admit it – for the first 6 months of using Kisssoft, I just clicked buttons and ran reports. If it said “OK,” I moved on.
Use Ctrl+F in the PDF. Searching for “Tip relief” or “Plastic gear” is 10x faster than clicking through the software’s help tabs.
But here’s the mistake I see too many junior engineers make: relying solely on the default settings and tooltips. kisssoft manual pdf
Do you keep a printed copy on your desk, or are you strictly digital? Let me know below.
It explains: âś… Why that warning really appears âś… How to customize reports âś… The exact standard behind each safety factor
👇
Find it in your install folder: Kisssoft\Docs\Manual_EN.pdf
You’re using Kisssoft wrong if you haven’t downloaded the full manual PDF.
Stop guessing. Start knowing.
Yesterday, I opened the (the 1,500+ page beast) and actually searched for a specific error code.
Not the quick-start guide. The 1,200-page beast.
