Siemens 828d Post Processor For Fusion 360 Apr 2026

// Drilling cycle (CYCLE81) function onDrillingCycle(section) var x = section.getX(); var y = section.getY(); var z = section.getZ(); // Final depth var retract = section.getRetractHeight(); var feed = section.getFeedrate(); var dwell = section.getDwellTime()

// Activate tool length offset writeBlock("D" + toolOffset);

function processOperations() var toolpath = getToolpath();

// Post processor entry point function onOpen() // Write program header writeBlock("% N " + getProgramName() + "_MPF"); writeBlock("; Generated by Fusion 360 Siemens 828D Post Processor"); writeBlock("; Date: " + new Date()); siemens 828d post processor for fusion 360

writeBlock(line);

// Machine specific settings writeBlock("SOFT"); // Soft acceleration writeBlock("FFWON"); // Feed forward on writeBlock("DYNON"); // Dynamic response on

// Set safe units and modes writeBlock("G90 G71 G40 G17 G64"); // Absolute, Metric, Cutter comp cancel, XY plane, continuous path mode writeBlock("G0 G60"); // Exact stop mode var y = section.getY()

// Modal states var currentWorkOffset = 0; var currentFeed = 0; var currentSpindleSpeed = 0; var currentToolNumber = 0; var currentPlane = "G17"; var currentUnit = "G71"; // Metric var currentAbsInc = "G90"; var currentCycle = "";

// Spindle speed and direction var spindleSpeed = tool.spindleSpeed; var spindleDirection = tool.clockwise ? "M3" : "M4";

// Output formatting function formatNumber(number, decimals) var formatted = number.toFixed(decimals); // Remove trailing zeros and decimal point if needed if (formatted.indexOf(".") > -1) formatted = formatted.replace(/.?0+$/, ""); var z = section.getZ()

if (!toolpath) return;

var line = clockwise ? "G2" : "G3"; // G2=clockwise, G3=counterclockwise

var line = "G1";

writeBlock(line);